Center the roof directly above the hearth (around which, in fact, everything zateivalos). Chase Koch addresses the importance of the matter here. At first I was afraid that because of the heat of the hearth, the tree above him can catch fire and planned to install a metal hood - the hood. However, for the fifth season, and the tree did not even smoked (!) So the idea with your backyard blast furnaces safely dead. Although at times the flames almost touched sheathing. But since there is no thrust, the direction of flow of hot gases is constantly changing and the tree perfectly chilled.
The distance between the crate and the source of the combustion zone - approx. 2 meters. Fair to say that the tree processed stains, which increases fire resistance of wood. To protect the hearth and sat beside him on the people side wind (which in our area are often those that fit the wind generator set), as well as for the device back to the bench it was decided to upholster a low wall, pergola. Wall height is such that would be a little high above the head of a man sitting on the bench, plus a small margin. This means the top level of the wall should be approximately 100 - 110 cm from the plane of the bench. But first, between the vertical supports are fixed with metal furniture parts cross to the back. For the convenience of the further work they are set above the level benches, as lower back still will not feel any stress. Prepared with a sufficient number of boards for the back and giving them top of the desired decorative form, you can proceed to the padding of the back. Necessary noted that the length of the board for the back should be about 150 cm (above 110 cm on the bench and almost 'to the ground' that would not muzzle but feet.
The distance between the crate and the source of the combustion zone - approx. 2 meters. Fair to say that the tree processed stains, which increases fire resistance of wood. To protect the hearth and sat beside him on the people side wind (which in our area are often those that fit the wind generator set), as well as for the device back to the bench it was decided to upholster a low wall, pergola. Wall height is such that would be a little high above the head of a man sitting on the bench, plus a small margin. This means the top level of the wall should be approximately 100 - 110 cm from the plane of the bench. But first, between the vertical supports are fixed with metal furniture parts cross to the back. For the convenience of the further work they are set above the level benches, as lower back still will not feel any stress. Prepared with a sufficient number of boards for the back and giving them top of the desired decorative form, you can proceed to the padding of the back. Necessary noted that the length of the board for the back should be about 150 cm (above 110 cm on the bench and almost 'to the ground' that would not muzzle but feet.
Posted by: |